BEEKEEPING LEARNING CENTER > TOP BAR HIVES - WARRE HIVES - LONG HIVES
Long hive sides are bowing outwards.
Bob Wilson:
I suspect so also, Cao. My 2X10s with a solid bottom board screwed underneath is not warping at all. It's only the 3/4 plywood and solid pine. And they are only bowing at the top. I plan on using 2X boards again in the near furure.
Michael Bush:
I have had the issue. I screwed a 2x2 or a 2x4 lengthways to stiffen and straighten it.
Bob Wilson:
Did it work very well, Michael? It would have to screwed from the inside out into the 2X4 to get a strong hold.
Michael Bush:
Yes, it has to be screwed from the inside if you are using a 2 by. It is a pain, but it worked for me. Keep in mind though that even a two by can warp. It helps if it's warped slightly n the opposite direction...
Navigation
[0] Message Index
[*] Previous page
Go to full version