BEEKEEPING LEARNING CENTER > EQUIPMENT USAGE, EXPERIMENTATION, HIVE PLANS, CONSTRUCTION TIPS AND TOOLS

painting occupied hives

(1/2) > >>

paus:
I want my wife to be gone when any painting is done around my place, for obvious reasons.  I want to paint some occupied hives.   May I open this can of (paint) worms.  I never heard of this and I can think of lots of scenarios  But I have no experience on which to make a decision.   

eltalia:
Having done stenciling because I had to at that time I have
never tested applying much more than that limited amount
of acrylic paint. I could only suggest trying the idea on a
small nucleus... let us know how that goes?

Cheers.

Bill

Joe D:
Over here it is hot, would figure it is in Texas to, you have bearding and bees here and there over the outside of the hives.  They would get paint on them which I can't think it would be good, and they may not like you painting their hive with them in it and get after you.  Do you
have boxes you can change out and then paint the hives with them empty.  I bought some hives one time that some of the brood boxes were bad I built some new one and replaced the bad boxes before moving.

Good luck, with whatever you decide,

Joe D

M3RLIN:
You can do it with spray paint as long as wind not blowing into entrance. It's redneck and not good practice but it works. Also your supers will join together with paint and tear when you unstick them.

little john:

--- Quote from: paus on August 18, 2017, 06:47:58 pm ---I want my wife to be gone when any painting is done around my place, for obvious reasons.
--- End quote ---
Are you thinking that she'll then draw up a list of other stuff that needs a coat of paint ?  :smile:
FWIW, I only ever paint during a swap-out - that way the box can be checked over at the same time, propolis build-up removed and so forth.  And - if any hairline cracks have developed, then these can be treated with waterproof glue.

Painting during a swap-out also enables the box edges to be painted - not everyone does this of course - but if you do, then rub some beeswax onto the edges when it comes time to replace the box - this will stop the edges sticking together.
LJ

Navigation

[0] Message Index

[#] Next page