Beemaster's International Beekeeping Forum
BEEKEEPING LEARNING CENTER => HONEYBEE REMOVAL => Topic started by: BeeMaster2 on August 20, 2018, 10:34:29 pm
-
Here is a removal that I completed today.
Note the name of the store that the hive built their hive over. Ironic.
The hive is under that metal cap, right next to the pipes. The pipes were actually pinning the cap down. We did not know it but the front of the cap was folded under a metal strip that was nailed to the front of the cornice. It made it very difficult to remove the cap.
After we removed the cap, here is what we found. A rubber seal with plywood under it. We were expecting fiberglass over styrofoam, plywood was much easier.
Sorry, photos got messed up and even after several attempts, I could not fix it.
Continued
Jim
-
Her is what we found when we lifted the plywood.
Here I am vacuuming up bees. These are very gentle bees. We did get run off once when I lifted a large section of comb that had collapsed due to the heat. I think I did get one sting. John took 3 stings.
Here is John.
Continued
Jim
-
Here you can see the comb and the piece that collapsed.
After I removed the comb, I found that a lot of bees were hiding in the section to the left of the comb. I put my camera inside a small hole to get this picture. I vacuumed up as many as I could, not easy and then used Beequick to get them out. It took several repeated sprays to move them.
Here is the void after the comb was removed.
When I was done I reinstalled the plywood and sealed the cuts with duct tape.
-
Then I replaced the rubber seal and sealed the seams with duct tape.
My job was to remove the bees and to temporarily close it up.
Here I replaced the metal cap.
I did seal up the entrance from the inside to keep the bees from returning. There were about 20 bees that stayed at the entrance.
Jim
-
Hope this will help someone that might get to do the same type of removal.
Jim
-
That was a fine job that y'all did! Very intreating. You never know what you are going to run into when doing a project like this. Y'all handled it well and a very professional job at that!! Thanks for the pictures and sharing the experience and information. How did y'all get all your equipment up and down the top of the building? That must have been a job in itself! Thanks again, Phillip Hall "Ben Framed"
PS And how convient for the proprietor (Brazils Waxing Center). They could buy back the wax form you and claim to have on he premises produced organic wax!! :wink:
-
Jim, what a great job done. Very professional too!
Thanks for sharing.
-
Good job. Reminds me of this one.
-
Phil,
We used the vertical ladder/hatch dooor that was in the mechanical room. Used a rope to pull everything up, and then when done-down. I was glad it was there. The alternative was to pull it up and over that wall, no thanks.
Thanks for all of the nice comments.
Jim
-
You are welcome, I had one a few weeks ago that was tough to get to. Was completely on the farthest place on the houseIt was so hot and I had no help. By the time I had lugged everything around (up concrete steps, decks etc I was worn out before I started up the ladder!! I learned the true value of a wheel barrow. I went and picked it up , before it was time to reload the truck. Keep up the good work.. Phillip