BEEKEEPING LEARNING CENTER > EQUIPMENT USAGE, EXPERIMENTATION, HIVE PLANS, CONSTRUCTION TIPS AND TOOLS
Jeff Horchot Method of Coating Plastic Foundation
(1/1)
Ben Framed:
https://youtu.be/ijEIsxVlLhw
BeeMaster2:
Ben,
I made a dipping chamber from 2-4 inch pieces of 4x4 1/4? thick steel tubing. I cut out the one side of each one and welded them together and welded on a bottom plate. I put them over a propane flame. It is tall enough to shake off the excess wax back into the tank.
Jim Altmiller
Ben Framed:
--- Quote from: sawdstmakr on April 30, 2021, 09:26:10 pm ---Ben,
I made a dipping chamber from 2-4 inch pieces of 4x4 1/4? thick steel tubing. I cut out the one side of each one and welded them together and welded on a bottom plate. I put them over a propane flame. It is tall enough to shake off the excess wax back into the tank.
Jim Altmiller
--- End quote ---
Yes, that sounds good Jim. It worked out well? Do you have a way to determine the temperature so that it does not reach to high?
Navigation
[0] Message Index
Go to full version